Roofing Contractors in San Luis, Colorado

Yes. We connect San Luis homeowners in Costilla County with licensed, insured roofing contractors. Our network covers all of Colorado and is available 24/7 for emergency response, inspections, repairs, and full roof replacements in San Luis and surrounding communities. Call (877) 413-1365 to speak with a local Colorado contractor.

Hail damage on asphalt shingles appears as dark, circular bruising or divots where granules have been knocked away — often compared to a ball-peen hammer strike. Missing granules expose the underlying asphalt to UV degradation. In San Luis, any hail event over 1 inch warrants a professional inspection. We provide written damage assessments for Costilla County homeowners.

Ice dams form when heat escaping through the roof deck melts snow on the upper roof surface. The meltwater runs down to the cold eave overhang, where it refreezes. The resulting ice dam traps additional meltwater that backs up under shingles and infiltrates the interior.

Adequate attic insulation reduces heat loss through the deck. Balanced ventilation keeps the roof surface cold and uniform. Together, they eliminate the warm-roof/cold-eave temperature differential that drives ice dam formation.

Most building codes require 1 square foot of net free ventilation area per 150 square feet of attic floor area, split evenly between intake and exhaust. With a vapor barrier in the attic, some codes allow 1:300. Actual performance depends on product net free area ratings.

Excessive exhaust without corresponding intake draws conditioned air from the living space, reducing energy efficiency. In very high-wind environments, improperly protected exhaust vents can allow wind-driven moisture entry. Balance is the goal — not maximum exhaust.

Signs include excessive summer attic heat (above 150°F), frost on the attic deck in winter, mold growth on sheathing, prematurely aging shingles, ice dams in cold climates, and moisture staining or wet insulation without an obvious roof leak as the source.

Insulation installed without baffles at the eave can block soffit intake vents, preventing outside air from entering the attic. Rafter baffles maintain an air channel from soffit to attic even when insulation fills the rafter bay, preserving ventilation function.

Rafter baffles (also called vent chutes) are cardboard, foam, or plastic channels installed between rafters at the eave to maintain an air space above the insulation. They allow intake air from soffit vents to enter the attic without being blocked by insulation.

A power vent (power attic ventilator) is a motorized fan that actively exhausts attic air. They can create negative pressure that draws conditioned air from the living space if intake is inadequate. Passive ventilation systems are generally preferred by most building science professionals.

Solar attic fans provide active ventilation without operating cost. They're most effective in high-sun climates where the solar gain drives both the need for ventilation and the power to run the fan. They have the same negative pressure risks as electric power vents if intake is insufficient.

An unvented (hot roof) assembly uses closed-cell spray foam applied directly to the roof deck, bringing the attic into the conditioned envelope. It eliminates traditional ventilation and ice dam risk but requires HVAC design adjustment and is not appropriate for all situations.

Yes. Inadequate exhaust ventilation allows warm, humid air to remain in the attic where it contacts cold sheathing surfaces in winter, condensing and creating conditions for mold growth. The mold is often found on the north side of the sheathing where temperatures are coldest.

From the attic, check whether you can see daylight through the soffit areas and whether there's open air space between the insulation and the roof deck at the eaves. If insulation is packed to the sheathing with no gap, the intake path is blocked.

Net free area is the actual open area through which air can flow in a ventilation product, measured in square inches. It's always less than the physical opening size due to louver and screen obstructions. NFA is the correct figure to use when calculating ventilation requirements.