Roofing Contractors in Franklin, New Jersey

Yes. We connect Franklin homeowners in Sussex County with licensed, insured roofing contractors. Our network covers all of New Jersey and is available 24/7 for emergency response, inspections, repairs, and full roof replacements in Franklin and surrounding communities. Call (877) 413-1365 to speak with a local New Jersey contractor.

For coastal Franklin homes, impact-rated asphalt shingles (Class 4), metal roofing, and concrete tile offer the best wind resistance and salt-air durability. Corrosion-resistant fasteners are essential in coastal environments — standard galvanized steel degrades faster in salt air. Ask us about wind-rated and corrosion-resistant systems when you call.

Most building codes require 1 square foot of net free ventilation area per 150 square feet of attic floor area, split evenly between intake and exhaust. With a vapor barrier in the attic, some codes allow 1:300. Actual performance depends on product net free area ratings.

Excessive exhaust without corresponding intake draws conditioned air from the living space, reducing energy efficiency. In very high-wind environments, improperly protected exhaust vents can allow wind-driven moisture entry. Balance is the goal — not maximum exhaust.

Signs include excessive summer attic heat (above 150°F), frost on the attic deck in winter, mold growth on sheathing, prematurely aging shingles, ice dams in cold climates, and moisture staining or wet insulation without an obvious roof leak as the source.

Insulation installed without baffles at the eave can block soffit intake vents, preventing outside air from entering the attic. Rafter baffles maintain an air channel from soffit to attic even when insulation fills the rafter bay, preserving ventilation function.

Rafter baffles (also called vent chutes) are cardboard, foam, or plastic channels installed between rafters at the eave to maintain an air space above the insulation. They allow intake air from soffit vents to enter the attic without being blocked by insulation.

A power vent (power attic ventilator) is a motorized fan that actively exhausts attic air. They can create negative pressure that draws conditioned air from the living space if intake is inadequate. Passive ventilation systems are generally preferred by most building science professionals.

Solar attic fans provide active ventilation without operating cost. They're most effective in high-sun climates where the solar gain drives both the need for ventilation and the power to run the fan. They have the same negative pressure risks as electric power vents if intake is insufficient.

An unvented (hot roof) assembly uses closed-cell spray foam applied directly to the roof deck, bringing the attic into the conditioned envelope. It eliminates traditional ventilation and ice dam risk but requires HVAC design adjustment and is not appropriate for all situations.

Yes. Inadequate exhaust ventilation allows warm, humid air to remain in the attic where it contacts cold sheathing surfaces in winter, condensing and creating conditions for mold growth. The mold is often found on the north side of the sheathing where temperatures are coldest.

From the attic, check whether you can see daylight through the soffit areas and whether there's open air space between the insulation and the roof deck at the eaves. If insulation is packed to the sheathing with no gap, the intake path is blocked.

Net free area is the actual open area through which air can flow in a ventilation product, measured in square inches. It's always less than the physical opening size due to louver and screen obstructions. NFA is the correct figure to use when calculating ventilation requirements.

Yes significantly. Poorly ventilated attics can reach 150-160°F in summer, creating heat load that degrades shingles from below, dramatically increases HVAC cooling load, and shortens shingle service life. Effective ventilation keeps attic temperatures much closer to ambient outdoor temperature.

Ventilation corrections during replacement typically involve adding or enlarging soffit vents for intake, installing or extending continuous ridge vent for exhaust, and adding rafter baffles at the eaves to maintain the intake air channel. These are efficiently done at replacement time.